Avoid heat Excessive temperature of the engine piston c […]
Excessive temperature of the engine piston can easily lead to overheated combustion and cylinder lock; rubber seals, triangle belts, tires, etc. Overheating can cause premature aging, performance degradation, and shortened service life; electrical equipment coils such as starters, generators, regulators, etc., are overheated and are easily burned out.
Engine valve locks should be installed in pairs. If: missing or missing, the valve will lose control and the piston will be damaged. Once the locking devices such as cotter pins, locking screws, safety plates or spring washers installed on the engine connecting rod bolts, flywheel bolts, drive shaft bolts are missing, serious failures may occur during use; once the engine is used in the timing gear chamber If the grease nipple for lubricating the gear is missing, it will cause serious oil leakage.
If parts such as fuel filter, oil filter, air filter, hydraulic oil filter and various filters are too dirty, the filtering effect will become worse. Dirty parts such as water tank radiator fins, air-cooled engine block and cylinder head radiator fins, and cooler radiator fins will cause poor heat dissipation and high temperature.
The engine cylinder head gasket cannot be installed upside down, otherwise it will cause premature ablation and damage to the cylinder head gasket; the engine fan blades should not be reversed during installation; for directional pattern tires and chevron tires, the grounding mark after installation should be herringbone pointed Point to the rear.