• What is the process flow of automobile half shaft processing

    What is the process flow of automobile half shaft processing

    1. Select the material and cut, and determine the machining allowance at the same time, which is convenient for subsequent processing operations. 2. The semi-axle is forged with a tire mold on an air hammer, and the cap is swung with a pendulum mill. 3. Shot peening the half shaft. 4. Carry out the ... read more

    Jul 01,2021 News
  • How to judge the abnormal noise of the main reducer of a car

    How to judge the abnormal noise of the main reducer of a car

    Judging the fault based on the abnormal noise of the main reducer of the car is an important method to eliminate the car fault. To master this method, we must first clarify the general part of the car's abnormal noise. If the major part is wrong, it will inevitably take a lot of detours to find the ... read more

    Jun 24,2021 News
  • What are the components of a car drive axle

    What are the components of a car drive axle

    Main decelerator The main reducer is usually used to change the transmission direction, reduce the speed, increase the torque, and ensure sufficient thrust and appropriate speed. There are more types of main reducers: single-stage, double-stage, two-speed, wheel reducers, etc. 1. Single-stage final ... read more

    Jun 17,2021 News
  • How are auto parts front axle assembly parts assembled and adjusted

    How are auto parts front axle assembly parts assembled and adjusted

    How are auto parts front axle assembly parts assembled and adjusted? Cleaning, inspection and lubrication The parts should be cleaned before installation, check whether each part in the front axle assembly of the car is free of dirt and damage, and apply a thin layer of engine oil on the mating surf... read more

    Jun 09,2021 News
  • What are the reasons for the leakage of the gear reducer oil tank and the treatment plan

    What are the reasons for the leakage of the gear reducer oil tank and the treatment plan

    1. The pressure in the fuel tank rises In a closed reducer, each pair of gears meshing and friction will generate heat. As the running time increases, the temperature in the reducer case gradually rises, while the volume of the reducer case does not change, so the pressure in the box follows Increas... read more

    Jun 01,2021 News